Wool selection

REDA — Put wool at the center of the specification

Tailoring cloth is easier to compare when fibre content, weave, mass per square metre and cuttable width sit in the same brief.

Send a wool brief
First step
Name the cloth family or the jacket use, then add any cutting you already hold.
Large wool suiting swatch book beside one folded unbranded wool cloth on a cutting table
Handle, weave and colour belong with a physical cutting, not with a screen preview alone.

Wool cloth in view

Draped unbranded wool tailoring cloth showing weave and drape

Three checks before a shortlist

  1. Identify fibre content and any blend ratio on the declaration that travels with the cutting.
  2. Confirm weave or knit construction rather than treating GSM as a full description.
  3. Note the finish route, including milling, clear-cut face or a requested stain treatment, as a question.
Browse wool fabrics

Specification essentials

Fields to agree for wool tailoring cloth; no product performance is implied
Field Target question Evidence question
Composition State wool percentage and any companion fibre by mass. Keep the declaration with the approved cutting.
GSM Set a target mass and the tolerance you can accept. Record specimen state and the method used for that mass.
Usable width Separate cuttable width from full cloth width and selvedge. Confirm the width rule on the roll or piece you intend to cut.
Finish Describe milling, face finish or any treatment under review. Check whether the cutting shows the same finish state as the brief.

A written target is not a measured result for this site. One jacket brief can ask for 260–280 g/m², a 150 cm cuttable width, and wool by mass with any companion fibre named as the remainder, then leave yarn count blank until a cutting is identified. Another brief at the same mass can ask for a wool-polyamide blend because the priority is crease recovery and drying rather than a dry wool handle. Those are opposing fibre priorities, not a ranking. If an abrasion report is attached, its cycles and abradant still do not describe itch or how the cloth takes a crease; that part is settled on the cutting in the hand.

Composition
Clarify the wool blend
Width
Discuss cuttable area
Sample
Agree the review cutting

Have a wool reference?

Share the cloth description and the jacket, trouser or coat use.

Discuss the wool brief